Disc Pivot, Plain Head, Titanium, .498"D, 6-64 Thread, .15" Thread Length, T20 Torx Drive

In stock
Shelf Location
Bulk Discounts
  • Buy 2 for $7.37 each and save 5%
  • Buy 5 for $6.98 each and save 10%
  • Buy 10 for $6.60 each and save 15%
  • Buy 15 for $6.21 each and save 20%
  • Buy 25 for $5.82 each and save 25%
  • Buy 50 for $5.43 each and save 30%
Write Your Own Review
You're reviewing:Disc Pivot, Plain Head, Titanium, .498"D, 6-64 Thread, .15" Thread Length, T20 Torx Drive
Your Rating

.498" Plain Pivot Head

  • Plain Pivot Head
  • T-20 Torx drive
  • .498" Diameter head
  • .07" Head Thickness
  • 6-64 Fine Pitch Thread
  • .15" Thread Length under the head
  • Made of Titanium

Made in the USA all the way!

The 64tpi on these allows a much finer adjustment when dialing in your knife build.

This is a part of a three-part pivot system. You use two heads and a pivot barrel. We would also suggest adding a bushing to the barrel to fit blade/washer stack up perfectly. Some makers prefer a fancy pivot head on one side and a traditional screw head on the back side. We will also have button head screws in this fine pitch in #8 and #6 sizes in both stainless and titanium to fit one side of the knife.

This disc head was designed to be used as is or customized - mostly customized. You can chuck one into a hand drill and run it against your belt sander to dome or shape the pivot head. You can also drill, file, notch, whatever.

The disc head is .498" so you can use a standard 1/2" diameter cutter to countersink these.

These disc pivots were designed to go with our #6-64 thread Pivot Barrels.

We have a few lengths of pivot barrels available that fit this pivot head:

We can make custom pivots like these to your design or specifications in batches of 500 or more. Call for more information.

Note: Pictured are multiple Pivots. You are purchasing one single Pivot. If you want the Pivot head on both sides of your knife, order 2.