Disc Pivot, Plain Head, Stainless Steel, .498"D, 6-64 Thread, .15" Thread Length

In stock
Shelf Location
Bulk Discounts
  • Buy 2 for $3.85 each and save 5%
  • Buy 5 for $3.65 each and save 10%
  • Buy 10 for $3.44 each and save 15%
  • Buy 15 for $3.24 each and save 20%
  • Buy 25 for $3.04 each and save 25%
  • Buy 50 for $2.84 each and save 30%
Write Your Own Review
You're reviewing:Disc Pivot, Plain Head, Stainless Steel, .498"D, 6-64 Thread, .15" Thread Length
Your Rating

.498" Plain Pivot Head

  • Plain Pivot Head
  • No drive
  • .498" Diameter head
  • .07" Head Thickness
  • 6-64 Fine Pitch Thread
  • .15" Thread Length under the head
  • Made of Stainless Steel

Made in the USA all the way!

The 64tpi on these allows a much finer adjustment when dialing in your knife build.

This is a part of a three-part pivot system. You use two heads and a pivot barrel. We would also suggest adding a bushing to the barrel to fit blade/washer stack up perfectly. Some makers prefer a fancy pivot head on one side and a traditional screw head on the back side. We will also have button head screws in this fine pitch in #8 and #6 sizes in both stainless and titanium to fit one side of the knife.

These disc pivots were designed to go with our #6-64 thread Pivot Barrels.

We have a few lengths of pivot barrels available that fit this pivot head:

We can make custom pivots like these to your design or specifications in batches of 500 or more. Call for more information.

Note: Pictured are multiple Pivots.  You are purchasing one single Pivot. If you want the Pivot head on both sides of your knife, order 2.