Steel - Tool Bar Arms & tool rest 18" x1.5" sq x 1/8"

In stock
tool bar steel 18x1.5x.125
Shelf Location
Write Your Own Review
You're reviewing:Steel - Tool Bar Arms & tool rest 18" x1.5" sq x 1/8"
Your Rating

Steel for No Weld Grinder: Tool Bars and tool rest

  • 1.5"/sq x 18.1"long x 1/8" thick
  • This is mild steel for construction of the No Weld Grinder.

The plans call for at least 1 each of this part for each tool bar. Order 1 bar for each tool attachment you will make. I suggest a minimum of 3.

For the tool rest, you will need 2 of this part. This allows for 1ea tool table post. If you want additional tool tables, order 1 additional bar. Each bar will give you 3ea tool table posts.

To keep parts inventory down, I cut this to 18.25" inches. You will need to make additional cuts.

The parts, in most cases have been cut slightly longer than the plans call for so you can square up the ends. The cut edge(s) you measure from will almost certainly need to be squared up. Expect this steel to have some rust, dirt, grease and sharp edges from the cuts. No attention has been given to cosmetics. This is just like it comes from the metal dealer.  

I carry this mild steel as a last resort for those that can not find any steel locally. I have added a markup and a small cut charge to every piece. Nearly every item I carry, I try to be at or very near the best price in the business. This mild steel is probably a bit higher in price than you are going to find locally. I just don't have a whole sale source on this stuff and I simply can't stay in business not charging a mark up and time for cutting.




> no weld grinder sander plans kits parts contact wheels