Cross Cut Pin Sled- Made by Kyle H. Daily

In stock
Only 8 left
SKU
THP-KHD-PInGuide
Shelf Location
J2.3
$40.00

Cross Cut Pin Sled

  • The main sled body is 5.5″ by 4″ and is 1.125″ tall.  
  • There are three inserts (1/4″, 1/2″, 3/4″) to vary the gage length of the sled.  Select the appropriate length you want the pins and insert your pin stock.  Push the end of the pin so it is flush, holding the excess pin material, push the sled so the bandsaw blade cuts only the pin material.  I have found to get a little bit cleaner of a cut, I can rotate the pin material while cutting to get less of a burr at the end.  Pushing slowly also helps with this, allowing the blade to do more cutting than tearing.
  • Insert sizes available on this: 1/16″ → 0.073″, 1/8″   → 0.135″, 3/16″ → 0.198″, 1/4″   → 0.260″, 5/16″ → 0.323″, 3/8″  → 0.385″, 1/2″   → 0.510″

Note from Kyle: This is 3D printed, please exercise caution when cutting metal pins so they do not get too hot and melt the the PLA material. 

Write Your Own Review
You're reviewing:Cross Cut Pin Sled- Made by Kyle H. Daily
Your Rating