Corby Bolt - Titanium - LARGE - .250" shaft .312" shoulder
In stock
SKU
PP-121
Shelf Location
H1.6
$3.59
Bulk Discounts
- Buy 4 for $3.52 each and save 2%
- Buy 10 for $3.37 each and save 6%
- Buy 25 for $3.23 each and save 10%
- Buy 50 for $3.09 each and save 14%
- Buy 100 for $2.98 each and save 17%

Write Your Own Review
Corby Style Bolts
-
.250" Shaft Diameter .312" Shoulder Diameter
-
..35" Shaft Length .375" Shoulder Length
-
.32" long thread
-
Over all length is 1.11", Max Over all length is 1.30"
-
Titanium
-
both ends slotted
- Use these Corby style bolts to connect handles to a knife tang. For a full tang knife:
- You drill a hole in the tang the size of the shaft. Then you drill holes part way through the handle material the diameter of the shoulder.
- For a hidden tang knife:
- Dry mount your handle to the hidden tang so it doesn't move. Drill a hole through both handle and tang in one pass. Then drill the handle material partially to depth the diameter of the shoulder.
- Screw the two parts together fastening the scales to the tang. The ends of the bolts are slotted so you can use a screw driver on both ends to tighten the bolt. When you have it tight, you grind off the excess bolt material leaving a nice pin showing. You can also grind the shaft and/or threads to shorten them up. The shoulder and shaft are almost certainly longer than the thickest handle/tang combination.
- We have these custom made exclusively for us.
NOTE: These are sold in single bolts. You will probably need to order 2 of these for a typical knife handle. The picture shows several for clarity of illustration. You are ordering one each as shown above.