Corby Bolt - Aluminum - SMALL .140" shaft .187" shoulder
- Buy 4 for $1.89 each and save 2%
- Buy 10 for $1.81 each and save 6%
- Buy 25 for $1.74 each and save 10%
- Buy 50 for $1.66 each and save 14%
- Buy 100 for $1.60 each and save 17%
Corby Style Bolts
-
.140" Shaft .235" long shaft
-
.187" Shoulder .230" long shoulders
-
.240" long thread
-
Over all length is 1", OAL max length is 1.15"
-
Aluminum - Super light for when every bit of weight matters
-
both ends slotted
-
Use these Corby style bolts to connect handles to a knife tang. For a full tang knife:
-
You drill a hole in the tang the size of the shaft. Then you drill holes part way through the handle material the diameter of the shoulder.
-
For a hidden tang knife:
-
Dry mount your handle to the hidden tang so it doesn't move. Drill a hole through both handle and tang in one pass. Then drill the handle material partially to depth the diameter of the shoulder.
-
Screw the two parts together fastening the scales to the tang. The ends of the bolts are slotted so you can use a screw driver on both ends to tighten the bolt. When you have it tight, you grind off the excess bolt material leaving a nice pin showing. You can also grind the shaft and/or threads to shorten them up. The shoulder and shaft are almost certainly longer than the thickest handle/tang combination.
-
We have these custom made exclusively for us.
NOTE: These are sold in single bolts. You will probably need to order 2 of these for a typical knife handle. You are ordering one each as shown above in the description.
