Connector 1/4" x 1/4" 8-32 Threaded SS

In stock
Shelf Location
Bulk Discounts
  • Buy 2 for $1.89 each and save 5%
  • Buy 5 for $1.79 each and save 10%
  • Buy 10 for $1.69 each and save 15%
  • Buy 15 for $1.59 each and save 20%
  • Buy 25 for $1.49 each and save 25%
  • Buy 50 for $1.39 each and save 30%
Write Your Own Review
You're reviewing:Connector 1/4" x 1/4" 8-32 Threaded SS
Your Rating
Handle connector

This is the middle female connector only. 8-32 thread screws are sold separately.
This is one part of a 3 part connector system. This middle part is threaded with a 8-32 thread (#8 size screw and 32 threads per inch) sold separately.

This is machined from 300 series stainless steel for corrosion resistance. These are often referred to as stand offs in the electrical industry.

This connector system is used with a full tang knife. The middle part is placed in a drilled 1/4" hole in the tang. The handle scales are placed over the tang and with matching holes, screws are threaded into the connector from both sides. Screws are usually counter sunk and flush with the handle surface. Often, the screws and the middle connector may need to be ground slightly down to size.

NOTE: The picture is for illustration only showing how two screws would be used with this middle connector. You are ordering in eaches and only the middle connector for this item listing. SCREWS NOT INCLUDED