Atlas Stainless Graham Forge

In stock
Shelf Location
Write Your Own Review
You're reviewing:Atlas Stainless Graham Forge
Your Rating

Atlas Stainless Graham Forge

***These will be shipped directly from the manufacture***


“Our biggest, most advanced bladesmith forge yet!”

Want a better forge for bladesmithing, one that’s going to last longer, get hotter, and use less propane than forges on eBay and Amazon?  Then this is for you.  With a 5″ diameter x 13″ long chamber, the Graham has plenty of room for even the biggest kukri, and hot enough for big billets of Damascus.  With a blown burner now standard, you have complete control over your atmosphere.

The Graham forge uses Plicast LWI 24 cast refractory, cured, and baked for 6 hours at 450°F.  Ready to use right out of the box and it will last much longer than wool-based forges.

Want to weld in your forge, but aren’t comfortable with fluxless welding yet?  We recommend a bag of Plibrico’s Tuff Mix.  It is rock hard and virtually immune to flux.  Mix with a little water and form a flux proof bottom. (sold separately)

We include a bag of Plistix 900f.  Although not required for use, this easy-to-apply refractory is painted on the inside of the chamber and improves efficiency.  Simply mix with water, wet the chamber with a damp rag and paint the 900f on

We also improved the construction level of this forge.  With 1/8″ thick stainless tubing, TIG welded end plates, and a tough, cast refractory shell, it’s built to last!  Heck, we even managed to make the toolrest stronger.



  • Chamber measures 5″ diameter × 13″
  • 4″ × 2″‘ rear opening
  • Max temp of 2300° F
  • 390+ BTU per cubic inch
  • Hot enough to forge weld!
  • Welded leg plates with integrated toolrest holder


  • Forge w/ adjustable sliding tool rest
  • 20 PSI regulator w/hose connects to 20lb. propane tanks
  • New Firestorm 100k BTU blown burner (12VDC powered)
  • One 8oz bag Plistix 900F for flux resistant floor(not required)
Traditional 100k venturi burner available upon request