AEB-L Stainless Steel .125" Thickness - See Length Note

Out of stock
Shelf Location
Grouped product items
Product Name
AEB-L Stainless Steel .125" x 1" - Sold by the Foot
AEB-L Stainless Steel .125" x 1.5" - Sold by the Foot
AEB-L Stainless Steel .125" x 2" - See Length Note
AEB-L Stainless Steel .125" x 4" - Sold by the Foot
Write Your Own Review
You're reviewing:AEB-L Stainless Steel .125" Thickness - See Length Note
Your Rating

AEB-L Stainless Steel .125"

LENGTH NOTE:(Currently Applies to 1" and 4" Width Steel)

 We buy this in 36" lengths and sell it in 12", 24", 36" lengths.

 If you buy 1ea, you will get a stick 12" long by the width and thickness shown.

 If you buy 2, you will get a bar that is 24" in legnth.

 If you buy 3, you will get a bar that is 36" in legnth.

 **If you buy 2 or 3 and want 12" length pieces, please specify in the comments section that you would like them cut into 12" pieces.

 **Advertised price is for 1qty 12" piece

-Extremely easy to grind

-Heat treat like 440C

-Very easy to polish and buff


This steel is fully stainless steel but perform much like carbon steel. It is Descaled and Annealed.


CRA means cold rolled annealed and is important to be in the description. It means the steel was pressure rolled while cold but was annealed again to relief the stress and take it to the softest state from rolling under tremendous pressure. 


HR means hot rolled and this steel was rolled to thickness usually during the smelting process but maybe later. The steel generally will be half or nearly fully hard depending on the type. It may often have mill scale residue. This steel can be easily forged. It can also be ground via stock removal. Drilling a hole in the tang maybe hard to do with out a carbide bit. 


HRA is the same but the steel was later annealed to relieve stress and make it as soft as possible for easier machining. 


Several companies produce "powder" smelted steels. This is a premium smelting process that improves the mixing of alloy content and generally produces a finer grain structure as a result. The powder steels are nearly always annealed and can be assumed to annealed unless noted otherwise.

We found other products you might like!