Carbidizer - Tung Carb by Bebe Carbidizer
Write Your Own Review
Tung Carb by Bebe Manufacturing
This is a low cost carbidizer.
Use this tool to place a hardened surface on your knife edge or liner lock face.
This tool vibrates and creates a plasma arc between the tungsten element and the target steel. Every vibration creates a spark and plasma arc. The tungsten element is sacrificed and deposited in a thin layer on the target.
If you are using on a knife edge, plate only one side of the cutting edge. This allows untreated steel to wear away faster than the hard tungsten carbide side essentially making it self sharpening. I know this works just like this as I have proven it to myself. I use a 154CM blade around the warehouse here and constantly cut cardboard, straps and glass tape. This kind of cutting dulls the blade fairly quickly. I had to sharpen my blades every other week. I carbidized the edge of my knife and it got sharper with use and I haven't sharpened it in months. True story. If you are in the warehouse here some time, ask to see my personal carry knife and I will show you my Protech with a carbidized edge.
For a liner or frame lock use: Fit the lock as you would normally. Carbidize the Titanium lock side only. You will probably have to refit the lock as the carbide/tungsten deposited on the lock face will add a few thousands. The advantage is you have a hardened lock face that isn't as sticky and won't gall like Titanium. A very subtle but very nice finishing touch for your liner or frame locks.
If you have ever finished a liner or frame lock and taken just a hair too much off the lock face and end up with a loose fit (it happens), use a carbidizer to build up material on the lock face and tighten up your fit.
This is a low cost carbidizer.
Use this tool to place a hardened surface on your knife edge or liner lock face.
This tool vibrates and creates a plasma arc between the tungsten element and the target steel. Every vibration creates a spark and plasma arc. The tungsten element is sacrificed and deposited in a thin layer on the target.
If you are using on a knife edge, plate only one side of the cutting edge. This allows untreated steel to wear away faster than the hard tungsten carbide side essentially making it self sharpening. I know this works just like this as I have proven it to myself. I use a 154CM blade around the warehouse here and constantly cut cardboard, straps and glass tape. This kind of cutting dulls the blade fairly quickly. I had to sharpen my blades every other week. I carbidized the edge of my knife and it got sharper with use and I haven't sharpened it in months. True story. If you are in the warehouse here some time, ask to see my personal carry knife and I will show you my Protech with a carbidized edge.
For a liner or frame lock use: Fit the lock as you would normally. Carbidize the Titanium lock side only. You will probably have to refit the lock as the carbide/tungsten deposited on the lock face will add a few thousands. The advantage is you have a hardened lock face that isn't as sticky and won't gall like Titanium. A very subtle but very nice finishing touch for your liner or frame locks.
If you have ever finished a liner or frame lock and taken just a hair too much off the lock face and end up with a loose fit (it happens), use a carbidizer to build up material on the lock face and tighten up your fit.
