Our warehouse will be closed through April 10th, 2020, as a result of Minnesota’s state wide Stay at Home Order.
All orders placed now through April 10th will be sent once the Stay at Home Order is lifted, our team will get your order shipped as fast as possible.

During this time we will still be answering all phone calls and emails. - Follow our COVID-19 updates here.
 

Pivot Lap Interchangable Bushing - KnifeDogs - .280" Rod

Out of stock
SKU
FKP-PP-404
Shelf Location
I1.2
$16.29

Pivot Lap Interchangable Bushing

  • Quality KnifeDogs Brand
  • O1 steel Hardened to 61/62RC
  • .280" Bushing with Plunger



Use these pivot laps to sand down your pivot's or stand offs perfectly square and with perfect control.

How to use these - Method 1:
1. Select your bushing and put it into the base ("puck"). Tighten the set screw to pull the bushing bottom flush to the bottom of the puck. These are machined slightly off set so the bushing always pulls flush to the bottom of the puck.
2. Using a flat surface (granite - flat steel, glass - something flat), lay out a piece of sand paper. Start with a 120 grit.
3. Insert your pivot (or stand off) into the bushing and pushed plunger down on top of it. The pivot will want to fall out of the bottom hole.
4. Lay the whole thing on your sand paper and move it back and forth a few times while you are pushing down on the plunger. Each stroke takes a bit off your pivot.
5. Remove the pivot and measure. Repeat until you get the length you need.  It just took longer to read than it will take to do.

Method 2: Repeatable to a certain size:
1. Select your bushing and put it into the base ("puck"). Tighten the set screw to pull the bushing bottom flush to the bottom of the puck. These are machined slightly off set so the bushing always pulls flush to the bottom of the puck.
2. Using a flat surface (granite - flat steel, glass - something flat), lay out a piece of sand paper. Start with a 120 grit.
3. Stack spacer bushings (not included- Use tubing or a larger stand off sized to the exact length you need.) onto the plunger. Then insert your pivot (or stand off) into the bushing and pushed plunger down on top of it. The pivot will want to fall out of the bottom hole.
4. Lay the whole thing on your sand paper and move it back and forth a few times while you are pushing down on the plunger. Each stroke takes a bit off your pivot.
5. Remove the pivot and measure. Repeat until you get the length you need.  It just took longer to read than it will take to do.

 

 

Write Your Own Review
You're reviewing:Pivot Lap Interchangable Bushing - KnifeDogs - .280" Rod
Your Rating
We found other products you might like!
 
Our warehouse will be closed through April 10th, 2020, as a result of Minnesota’s state wide Stay at Home Order.
All orders placed now through April 10th will be sent once the Stay at Home Order is lifted, our team will get your order shipped as fast as possible.

During this time we will still be answering all phone calls and emails. - Follow our COVID-19 updates here.