Pillow Block Bearings 3/4" shaft UCP 200 series with remove inse
3/4" Shaft Pillow Block Bearings
- Shipping weight: 1.8lbs
- These pillow block bearings are UCP 200 series.
They are similar to the illustration but will vary slightly as I purchase these surplus in bulk where I can find them. This is a very common bearing type with clearly defined design parameters so mixed lots aren't a problem. These have at least one collar that has a set screw to lock it to the shaft. A grease zerk is typical of these bearings. You will need 2 of these for the No Weld Grinder.
NOTE: The No Weld Grinder plans call for 5/8" pillow blocks. Some builders want a 3/4" shaft (belt and suspender guys no doubt) so I've added the 3/4" pillow blocks as an option. Simply sub 3/4" pillow blocks on the plans. No change needed. Use a 3/4" drive shaft and 3/4" pulleys and it will work just fine.
www.midwestknifemakers.com no weld grinder sander plans kits parts contact wheels bearings