Disc Pivot, Plain Head, Titanium Anodized Teal (green), .373"D, 8-64 Thread, .15" Thread Length
- Buy 2 for $4.37 each and save 5%
- Buy 5 for $4.14 each and save 10%
- Buy 10 for $3.91 each and save 15%
- Buy 15 for $3.68 each and save 20%
- Buy 25 for $3.45 each and save 25%
- Buy 50 for $3.22 each and save 30%
Disc Pivot Head
TORX T-20 drive
.075" Head Thickness
8-64 Fine Pitch Thread
.15" Thread Length under the head
Made of Titanium
Made in the USA all the way!
The 64tpi on these allows a much finer adjustment when dialing in your knife build.
This is a part of a three part pivot system. You use two heads and pivot barrel. We would also suggest adding a bushing to the barrel to fit blade/washer stackup perfectly. Some makers prefer a fancy pivot head on one side and a traditional screw head on the back side. We will also have button head screws in this fine pitch in #8 and #6 sizes in both stainless and titanium to fit one side of the knife.
These disc pivots were designed to go with our #8-64 thread Pivot Barrels.
We have two lengths of pivot barrels available that fit this pivot head:
This disc head was designed to be used as is or customized - mostly customized. You can chuck one into a hand drill and run it against your belt sander to dome or shape the pivot head. You can also drill, file, notch, whatever.
The disc head is .373" so you can use a standard cutter in .375" diameter to countersink these.
We can make custom pivots like these to your design or specifications in batches of 500 or more. Call for more information.
Note: Pictured are muliple Disc Pivots and one Fine Pitch Pivot Barrel. You are purchasing one single Disc Pivot. If you want the Pivot head on both sides of your knife, order 2.
Note: The annodized colors may vary slightly from part to part and possibly on the same part. Annodizing isn't the same as paint. These are annodized in batches in a basket under agitation. The difference is subtle but we want you to be aware of it.