Corby Bolt - Brass - SMALL .140" shaft .187" shoulders *NEW SHAFT LENGTH

Out of stock
SKU
FKP-PP-116
Shelf Location
H1.6
$1.89
Corby Bolt - Brass - SMALL .140" shaft .187" shoulders

Corby Style Bolts

  • .140" Shaft .54" long shaft

  • .187" Shoulder .223" long shoulders

  • .240" long thread

  • Over all length is 1", OAL max length is 1.15"

  • Brass
  • Both ends slotted

  • Use these Corby style bolts to connect handles to a knife tang. For a full tang knife:
    • You drill a hole in the tang the size of the shaft. Then you drill holes part way through the handle material the diameter of the shoulder.
  • For a hidden tang knife:
    • Dry mount your handle to the hidden tang so it doesn't move. Drill a hole through both handle and tang in one pass. Then drill the handle material partially to depth the diameter of the shoulder.
  • Screw the two parts together fastening the scales to the tang. The ends of the bolts are slotted so you can use a screw driver on both ends to tighten the bolt. When you have it tight, you grind off the excess bolt material leaving a nice pin showing. You can also grind the shaft and/or threads to shorten them up. The shoulder and shaft are almost certainly longer than the thickest handle/tang combination.
  • We have these custom made exclusively for us. 

NOTE: These are sold in single bolts. You will probably need to order 2 of these for a typical knife handle. The picture shows the 4 sizes we have in both Brass and 303 Stainless for reference. You are ordering one each as shown above.

Write Your Own Review
You're reviewing:Corby Bolt - Brass - SMALL .140" shaft .187" shoulders *NEW SHAFT LENGTH
Your Rating