Corby Bolt - 303SS - SMALL .140" shaft .187" shoulders

Out of stock
SKU
PP-115
Shelf Location
H1.6
$1.72
Bulk Discounts
  • Buy 4 for $1.69 each and save 2%
  • Buy 10 for $1.62 each and save 6%
  • Buy 25 for $1.55 each and save 10%
  • Buy 50 for $1.48 each and save 14%
  • Buy 100 for $1.43 each and save 17%

Corby Style Bolts

  • .140" Shaft .5" long shaft

  • .187" Shoulder .230" long shoulders

  • .220" long thread

  • Over all length is 1", OAL Max Length is 1.15"

  • 303 Stainless Steel

  • both ends slotted

  • Use these Corby style bolts to connect handles to a knife tang. For a full tang knife:
    • You drill a hole in the tang the size of the shaft. Then you drill holes part way through the handle material the diameter of the shoulder.
  • For a hidden tang knife:
    • Dry mount your handle to the hidden tang so it doesn't move. Drill a hole through both handle and tang in one pass. Then drill the handle material partially to depth the diameter of the shoulder.
  • Screw the two parts together fastening the scales to the tang. The ends of the bolts are slotted so you can use a screw driver on both ends to tighten the bolt. When you have it tight, you grind off the excess bolt material leaving a nice pin showing. You can also grind the shaft and/or threads to shorten them up. The shoulder and shaft are almost certainly longer than the thickest handle/tang combination.
  • We have these custom made exclusively for us. 

NOTE: These are sold in single bolts. You will probably need to order 2 of these for a typical knife handle. The picture shows the 4 sizes we have in both Brass and 303 Stainless for reference. You are ordering one each as shown above.

Write Your Own Review
You're reviewing:Corby Bolt - 303SS - SMALL .140" shaft .187" shoulders
Your Rating