Atlas Hellfire Blacksmith Forge

Out of stock
Atlas Blacksmith Forge
Shelf Location

Atlas Hellfire Blacksmith Forge

***These will be shipped direct from the manufacture***

“Introducing our new budget line of blacksmith forges.”

Simple and affordable, these are inswool lined forges.
Designed to have the front and rear partially blocked by firebricks
We include a bag of Satanite 3000° refractory to line the shell for longer life
We include a bag of Kastolite/Plibrico to build a flux resistant bottom 

5″ x 12″ open-ended chamber
Removable/adjustable legs for uneven surfaces (stumps, ground, etc.)
100k BTU burner
0-20 PSI regulator
16 oz. Kastolite LI30 flux-resistant mortar
12 oz. Satanite 3000° refractory mortar

Some assembly required.
1. Install the included leg bolts
2. Install the included 8-32NC bolts into the burner port
3. Mix the Kastolite/Plibrico powder with water, a little at a time, until paste-like. Use this mixture to build a bottom for the forge chamber.
4. Mix a splash of water with the Satanite and mix until wet, coat the entire inside of the forge. Allow to dry overnight.

Be aware that the bricks are very fragile and will crack due to expansion from heating, moisture, etc. This is normal and unavoidable. We have used thermal imaging to inspect the forges during use and have found that it does NOT affect the performance of the forge.


Do not operate until you have coated the wool with refractory

Write Your Own Review
You're reviewing:Atlas Hellfire Blacksmith Forge
Your Rating