Customer Service (507) 720-6063

Welcome guest! Please sign in to save your wishlists and cart.

123 Block Set

Steel 1-2-3 Blocks pair

More Views

  • Steel 1-2-3 Blocks pair
123 Block Set

SKU: 1720123 block set

Availability: In stock

$24.82



Details

1 2 3 Block Set



You want a set of these. Seriously. You will use these several times on every knife you build.

Used in layout and setup work. Each set consists of 2 matched, hardened and precision-ground blocks. The squareness on all sides is within .0001" per inch. The blocks are supplied with a plus allowance of .0001" to .0003" to allow nominal lapping. Five 3/8"-16 tapped holes are provided for clamping.

Here's the deal with these. A 123 block is maybe one of the most commonly used and mis-used machinist tools ever. These are commonly used for set ups for filler, to elevate a part or to get parts square. These things are handy as a pocket.

They are called 123 blocks because one they are 1" thick, 2" wide and 3" high.
They are at least half hard. It depends on the manufacture how hard they are but generally to hard to drill with out a carbide drill bit.

Tip: These are AWESOME for use on your drill press. Instead of adjusting your table height all the time, use one of these centered over one of the holes. It will be much easier to hold your work.
Also, have one on your work bench. Pins, pivots and such are often hard to remove in a tight fit up. Use these as punch blocks to tap out the stubborn stuck part with a blunt point punch.

I keep one one on my drill press and one on my bench.

Tip: You can use these as a poor mans file guide since these are fairly hard. Use 4ea long bolts (2.5" long) and bolt them together at the four corners. Open them up just wide enough to fit your knife blank in between. Line the edge of the blocks up where you want your plunge cut you are going to hand file. Tighten up and file against the 123 blocks as a guide.
 

Customer Reviews 1 item(s)

Very handy
I already had one pair, but ordered another pair to keep close to my other drill press. I keep finding new ways to use them. If you don't have a pair you should get these, you'll wonder how you ever did without them!
Quality
General Rating
Price
Value
Review by Jimmy / (Posted on 12/23/2013)

Write Your Own Review

Only registered users can write reviews. Please, log in or register

Shelf Location: J2.1