Customer Service (507) 720-6063

Welcome guest! Please sign in to save your wishlists and cart.

Heat Treat Foil (Tool Wrap) 321 .002"x24"x100' up to 2000F

Heat Treat Foil (Tool Wrap) 321 .002"x24"x100'  up to 2000F

Heat Treat Foil (Tool Wrap) 321 .002"x24"x100' up to 2000F

SKU: HTA-321-wrap-24"x100'

Availability: In stock

$257.14



Details

Heat Treat SS Foil

  • type 321
  • commonly called Tool Wrap
  • .002"x24"x100'
  • For use up to 2000F degrees
  • All-Foils quality Stainless Steel




**This is a drop ship item.  It will ship directly from our supplier to you.  Your other items ordered will ship separately from us.


Use this higher temperature rated tool wrap for steels that require 1900F or less heat treat. This is an area where you want some margin so use this for 1900F and type 309 for the higher temps. 

Tips: Wrap your knife one or two (at most) at a time making an airtight envelope. Fold over the seam twice and tap the seam closed with a hammer.  The seam is to the side, not on 'top' of the blade - this matters later. I try to wear leather gloves any time I handle this stuff. The edges on this are razor sharp. You will believe me when you cut yourself. It's just a matter of time. Handle it with respect.

Some guys put a piece of paper inside the envelope to burn up the oxygen so the blade steel does not carborize. I don't see much advantage to this. Just wrap it tight and there won't be any oxygen to speak of. Ideally, the envelope will tighten around the blade making solid contact.

If you plate quench, simply leave it in the envelope and quench it inside the tool wrap. If you oil quench, you need to wrap it a little looser so you can snip the foil pouch open and dunk the blade quickly.

Plate Quenching: Get scrap aluminum plates at least 1" thick. Make it a couple inches longer and at least 4" wider than your knives. When it comes time to quench, move quickly and put the (scary, hotter than hell!) foil pouch with blade blank in between the plates and press. Some guys use a wood vise plates installed. I just press with my hand. Once between the plates, I shoot compressed air in the gap to help cool it down even quicker. For compressed air, I charge up a portable air tank from my compressor and use that up. Those little red air tanks are sold every where.

Wear safety gear. I wear heavy welding gloves on both hands. I use a long tong to grab the foil pouch. I make sure the oven is OFF (getting shocked at 240v will kill you!) when pulling out the (scary, hotter than hell!) foil pouch. Holding a 1950F degree burning hot foil pouch with a blade in it is no time to figure out you are not ready. Practice a few times first before your first run.

Note: Picture is for illustration only.

Be the first to review this product

Write Your Own Review

Only registered users can write reviews. Please, log in or register

Shelf Location: DS