Customer Service (507) 720-6063

Welcome guest! Please sign in to save your wishlists and cart.

CTS-XHP *Surface Ground .125" Thickness - See Length Note

CTS-XHP Stainless Steel

CTS-XHP *Surface Ground .125" Thickness - See Length Note

SKU: MESS-CTS-XHP-.125

Availability: In stock


CTS-XHP Stainless Steel

CTS-XHP *Surface Ground .125" x 1" - read length note

$22.00
CTS-XHP Stainless Steel

CTS-XHP *Surface Ground .125" x 1.5" - read length note

$30.00


Details

CTS - XHP

 

LENGTH NOTE:

 We buy this in 36" lengths and sell it in 12",  24" and 36" lengths.

 If you buy 1ea, you will get a stick 12" long by the width and thickness shown.

 If you buy 2, you will get a bar that is 24" in legnth.

 If you buy 3, you will get a bar that is 36" in length.

 **If you buy 2 and want 12" length pieces, please specify in the comments section that you would like them cut into 12" pieces.

 **Advertised price is for 1qty 12" piece

 

 

CTS XHP stainless steel has been hard to source in the custom knife maker market so it isn’t well known. It is powder technology smelting so it is fine grained and clean.

 

Carpenter CTS-XHP is often compared to Crucibles S30V steel. The steel has slightly better edge retention and great corrosion resistance as compared to S30V. It does give up a bit of toughness to CPMS30V. This steel outperforms 440c in all three categories of edge retention, toughness and corrosion resistance. It’s going to make a great slicing and cutting steel on a fixed blade, folder or kitchen knife. It’s not going to be the best choice for a chopper. Check around the net on cutting tests and other performance tests. It has always done well and is a high performing steel we in the custom world should know more about. The issue has been Carpenters business model ignores the custom knife steel market. It’s too small for them to bother with. We worked with their only wholesale distributor and developed a distribution channel we can work with and we can now bring this steel to market. 

 
 
This steel likes to work at 60 to 61HRC

Bring to 1400/1500F and equalize (let it soak for 10 minutes)

Bring it up to 1850F/2000F (I prefer 1950F) for 30 minutes

Quench in air or plate quench.

Temper 400F to 600F twice at 2 hours each. Cool to room temperature in between tempers. Temper at 400F for 60.5HRC

 

There does not seem to be any data around cryo treatment but as typical with all these “super stainless steels” there is probably some benefit from cryo treatment between quench and tempering.

 

 Carbon 1.6%

Silicon .40%

Nickel .35%

Vanadium .45%

Manganese .50%

Chromium 16.0%

Molybdenum .80%

Be the first to review this product

Write Your Own Review

Only registered users can write reviews. Please, log in or register

Shelf Location: PR10.4