CPM 10V .103" Thick x 4" Wide
We buy this in 36" lengths and sell it in 12", 24" and 36"lengths.
If you buy 1ea, you will get a stick 12" long by the width and thickness shown.
If you buy 2, you will get a bar that is 24" in legnth.
If you buy 3, you will get a bar that is 36" in legnth.
**If you buy 2 or 3 and want 12" length pieces, please specify in the comments section that you would like them cut into 12" pieces.
**Advertised price is for 1qty 12" piece
CPM Tool Steel Grades
Just as CPM processing can allow higher alloy content for red hardness and wear resistance in high speed steels, it can also be used to produce high alloy cold work tool steels for increased wear resistance. The wear resistance of a tool steel is determined by the heat treated hardness and the amount and type of hard alloy carbides present in the microstructure. The cold work tool steels known for superior wear resistance typically contain significant amounts of vanadium with sufficient carbon to form high volumes of vanadium carbides.
CPM 1-V has shock resistance close to S-7 and wear resistance close to A-2. CPM 3V provides impact toughness approaching that of S7 and wear resistance higher than D2. CPM 9V is a modification of CPM 10V with lower carbon and vanadium to improve toughness and heat check resistance. These enhanced properties permit CPM 9V to perform well in problem applications where high carbon, high chromium tool steels, such as CPM10V or the high speed steels, lack sufficient toughness or where lower alloy tool steels and hot work tool steels lack sufficient wear resistance. CPM 10V has four times the wear resistance of D2 at the same toughness. CPM 15V was developed to withstand extreme wear conditions where carbide fractures and CPM 10-V is not wear resistant enough.
The exact chemistry of the following grades is proprietary information of Crucible Industries LLC. Only the nominal content is given unless otherwise stated.
|CPM 4-V TM||1.35||0.40||-||-||.80||5.0||3.85||-||2.95|
CPM, 1V, 3V, 9V, 10V, 15V, S90V, S110V, and S125V are registered trademarks of Crucible Industries LLC