Fury Skinner S509 Satin

Fury Skinner S509 Satin

Specs:

 - OAL: 8 1/4"

- Cuttin edge: 4 1/8"

 - Thickness: 3mm

- 2- 7/64" pin holes and 2- 1/8" pin holes

 - 9CR14 stainless steel

This drop point skinner was designed by Brad Wallace. This is a must for any knifemaker. Simple yet functional design.

NOTE: These knife blanks are already heat treated and hardened. All you need to do is add a handle and maybe a sheath. We suggest adding a pair of G10 scales in 3/16" or 1/4" thick material for the handle. You could also add some handsome wood scales from our extensive assortment or even from your own stock.

9CR14 stainless steel is very similar to 440C which is possibly the most popular knife steel in use today. It takes and holds a good edge. It has good corrosion resistance and is tough enough the edge won't chip out. 440C offers a good performing steel at a good price. Finally it can easily sharpened. Don't confuse 440C with lower quality 440A you find on low end knives. 440C is quality steel that has a good balance of edge holding, toughness and corrosion resistance that has stood the test of time.