Micro Roller Bearing 1/4" ID 1pair
Out of stock
SKU
FKP-WB-RollerBearing-5502
Shelf Location
I1.8
$6.14
Write Your Own Review
Micro Roller Bearing
NOTE: Sold as a pair.
Use an 11/16" Counterbore with 1/4" pilot to recess these bearings. We sell these counterbores in the "taps, reamers, countersink/bore" area.
NOTE: These will be a press fit for a 1/4" barrel pivot. You will need to stretch the ID for a loose fit. Use a tapered punch to stretch the ID to a slightly larger size.
Drill a 1/4" hole in some thick material. Use a punch that has a taper smaller than 1/4" on the point and larger than 1/4" on the shank. Insert the punch through the bearing hole and then into the 1/4" hole you have drilled. Give the punch a light tap to stretch the ID of the bearing slightly. The bearing will be stuck to the punch, carefully tap it loose from the punch and check the bearing for proper clearance. You want a non-interference fit on the pivot bearing. Repeat as needed.
- 1/4" Inside Diameter
- .678" OD
- .078" Thick
NOTE: Sold as a pair.
Use an 11/16" Counterbore with 1/4" pilot to recess these bearings. We sell these counterbores in the "taps, reamers, countersink/bore" area.
NOTE: These will be a press fit for a 1/4" barrel pivot. You will need to stretch the ID for a loose fit. Use a tapered punch to stretch the ID to a slightly larger size.
Drill a 1/4" hole in some thick material. Use a punch that has a taper smaller than 1/4" on the point and larger than 1/4" on the shank. Insert the punch through the bearing hole and then into the 1/4" hole you have drilled. Give the punch a light tap to stretch the ID of the bearing slightly. The bearing will be stuck to the punch, carefully tap it loose from the punch and check the bearing for proper clearance. You want a non-interference fit on the pivot bearing. Repeat as needed.
